Clutch fork pin is going no where!
#1
Clutch fork pin is going no where!
Hi everyone. I have one huge problem unless one of you kind people can help. The 6m threaded hole thats in the center of the pin so you can stick a bolt in or something to aid in pulling it out, well i put a relevant size bolt in and it bloody sheared off, FLUSH with the pin! Now i am right up **** creek. I have already tried metal glueing a nut onto the face and putting a bolt into that and it just popped off! Any ideas please or i am going to start adding "speed holes" to the car!
#4
I guess your changing the clutch, if so undo the pressure plate bolts through the starter hole, take the pressure plate out with the gearbox then remove afterwards. oh and the clutch plate will fall out the bottom, if your not replacing the clutch plate then catch it before it hits the deck.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
MightyArsenal
Wheels, Tyres & Brakes
6
25 September 2015 08:31 PM