sensor question
#1
sensor question
Hi all,
Ive got a 95 wrx and just changed the original cat for a 99 typre r one off one of the guys on here (nice one!!) but there is a hole, which i think is for a sensor on the right side of the cat at the top where it meets the turbo and want to know first if it is a sensor and how do i get hold of one to fit the connecter block on the car
cheers steve
Ive got a 95 wrx and just changed the original cat for a 99 typre r one off one of the guys on here (nice one!!) but there is a hole, which i think is for a sensor on the right side of the cat at the top where it meets the turbo and want to know first if it is a sensor and how do i get hold of one to fit the connecter block on the car
cheers steve
#2
hi mate its the lambda sensor hole yours will be in the manifold, it just wants a blanking plug putting in it there only a few quid most good subaru specialists should sort you out or i think you can pick up a sump plug from halfords that fits
Last edited by w13dle; 31 May 2009 at 09:14 PM.
#3
Thanks w13dle, there was a sensor on the original cat but it's too small for the new one, i quess just by blanking the hole off the car will run normally?? or is that sensor important for the ecu?
cheers
cheers
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM