well as the title says i have a overboosting problem i fit another engine to my scooby because me other went pop well at the same time i changed the exhaust, it boost right up to about 19 psi in which i believe is very bad i have got a boost control valve fitted but its not plumb in yet or set up as i don't have the know how on setting it up can any one help me please as not had the car long and not had a lot of luck with it ever

 

anyone

 

Check all boost pipes are correctly fitted, diss the boost controller and clean out the standard boost controll solonoid. If this still doesnt work lengthen the actuater arm so it runs less boost.

 

the soloniod was fine with my last engine i haven't plumbed in the boost controller let where abouts should i put it in the system if anyone has a pic of a 98 wit one fitted

 

What type of boost valve is it?

 

hi it is a bcu+ boost controller and the standard boost soloniod is a two port, i have found the instructions on the internet but they are not very helpful, as i have said i haven't plumbed the boost controller soloniod in yet but i don't know where to put it, i think it is meant to go between the acuator and the boost pipe but there is a resistrictor in there so do i fit that too i just want some one that knows what there doing.

 

anyone

 

bcu+ boost controller.
dont fit it, bad news seriously, little black box 2 silver dials, got timer et,,, peak, warn etc, get your money back, its a copy part, blew mine up set boost to 16psi went all way to 30
jj