Turbo Intake Pipe Replacement
26 April 2009, 01:30 PM
#1
Turbo Intake Pipe Replacement
Now that my MAF isn`t used I would like to replace my current air intake setup which has an HKS filter and OEM T.I.P.
My question is, do I need to take off the manifold to remove the T.I.P as on mine, the T.I.P goes under the manifold. Or can I replace it without having to remove the manifold as well.
Any tips on removing it ?
My question is, do I need to take off the manifold to remove the T.I.P as on mine, the T.I.P goes under the manifold. Or can I replace it without having to remove the manifold as well.
Any tips on removing it ?
26 April 2009, 03:54 PM
#2
Scooby Senior
iTrader: (3)
Join Date: Jun 2006
Location: Slowly rebuilding the kit of bits into a car...
Posts: 14,333
Likes: 0
Received 0 Likes
on
0 Posts
I didn't manage to get mine on without lifting the inlet manifold....
Doesn't mean someone on here hasn't managed it, some how !
"Chop" the old one up, break the connections off, and it will pull out. But I couldn't get my new one in as it's very tight on the manifold just next to the turbo.
HTH
dunx
P.S. Clean away loose debris before starting, as it will drop down into the heads given half a chance.
Doesn't mean someone on here hasn't managed it, some how !
"Chop" the old one up, break the connections off, and it will pull out. But I couldn't get my new one in as it's very tight on the manifold just next to the turbo.
HTH
dunx
P.S. Clean away loose debris before starting, as it will drop down into the heads given half a chance.
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
blockhead
Subaru Parts
19
07 November 2015 11:50 PM
aaron_ions
General Technical
1
17 September 2015 10:42 AM