Notices
General Technical
Sponsored by:
Sponsored by: CARiD

Knocklink goes nuts on De-Acceleration at speed

Old Apr 19, 2009 | 08:36 PM
  #1  
The Rig's Avatar
The Rig
Thread Starter
Scooby Regular
20 Year Member
iTrader: (13)
 
Joined: Dec 2002
Posts: 7,891
Likes: 8
Default Knocklink goes nuts on De-Acceleration at speed

On the track of course.

when doing 100 mph the knocklink is just flashin 1 green but when i take my foot off the loud pedal it will light up 2 green and at 140 mph there are 2 green lites lit but again,when de-accelerate they all light up and the red one.

if i put my foot back on the pedal they go back down to the 2 green/1 amber at 140 mph.

but when i coast off the throttle they all lite up and the red for a few seconds.


Anything to worry about ?

should note

classic import, z4 ecu,td05 turbo,ninja sports cat pipe,hks full sysem,standard airbox. runnin on v power standard map

Last edited by The Rig; Apr 19, 2009 at 08:38 PM.
Reply
Old Apr 20, 2009 | 09:20 AM
  #2  
Butty's Avatar
Butty
Scooby Regular
iTrader: (2)
 
Joined: Oct 2000
Posts: 5,254
Likes: 1
From: MY06 STi Spec D
Default

Heat shield loose?
Reply
Old Apr 20, 2009 | 10:17 AM
  #3  
The Rig's Avatar
The Rig
Thread Starter
Scooby Regular
20 Year Member
iTrader: (13)
 
Joined: Dec 2002
Posts: 7,891
Likes: 8
Default

Hmm, i do have a loose headers heat shield, it has split at the bolt so it vibrates sometimes but would that really cause enough vibration for the knocklink to pick it up so drastic ???
Reply
Old Apr 20, 2009 | 11:06 AM
  #4  
jasonius's Avatar
jasonius
Scooby Regular
iTrader: (1)
 
Joined: Oct 2004
Posts: 4,791
Likes: 0
From: Half way up
Default

Only one way to find out..

Try and 'bung' it up some how, even temporarily. A bit of gaffer tape on the cold side should do it..

FWIW, drive train noise does cause KL to go crazy as it sits right on top of bell housing. Mine lights up light a cheap night in blackpool if tyres break traction under power (wheel spin). Coming off the gas at high revs will could cause enough tranny noise to set KL off, but as nick says loose heat shield has to be the first port of call.

Does it not light up if you lift off in say 3rd at similar rpm..?
Reply
Old Apr 20, 2009 | 11:12 AM
  #5  
The Rig's Avatar
The Rig
Thread Starter
Scooby Regular
20 Year Member
iTrader: (13)
 
Joined: Dec 2002
Posts: 7,891
Likes: 8
Default

will try the de-acceleration in 3rd and see if that does the same,dont really de-accelerate in 3rd and kept in 3rd so never noticed.

the heat shield is broke right on the bracket/bolted bit so will see what i can do

cheers
Reply
Old Apr 20, 2009 | 12:55 PM
  #6  
Aztec Performance Ltd's Avatar
Aztec Performance Ltd
Former Sponsor
iTrader: (234)
 
Joined: Jan 2003
Posts: 14,406
Likes: 0
From: Over 500ft/lbs of torque @ just 1.1bar
Default

Lift off det: Might be worth a read Detonation, det cans, knocklink - findings so far, and questions.... - 22B Bulletin Board
Reply
Old Apr 20, 2009 | 01:09 PM
  #7  
The Rig's Avatar
The Rig
Thread Starter
Scooby Regular
20 Year Member
iTrader: (13)
 
Joined: Dec 2002
Posts: 7,891
Likes: 8
Default

cheers,plenty to read through there !

thanks
Reply
Old Apr 20, 2009 | 05:58 PM
  #8  
The Rig's Avatar
The Rig
Thread Starter
Scooby Regular
20 Year Member
iTrader: (13)
 
Joined: Dec 2002
Posts: 7,891
Likes: 8
Default

cheers again for the link,i read 2 pages of it and i got the impression most have 3rd party devices/software other than knocklinks and didnt really find anything on De-acceleration at speed,unless i went into a reading blur ha ha

cheers again tho
Reply
Old Apr 20, 2009 | 06:28 PM
  #9  
dj219957's Avatar
dj219957
Scooby Regular
20 Year Member
 
Joined: Dec 2003
Posts: 3,708
Likes: 1
From: Staffs
Default

the z4 ecu is not mapped very well to go past 112mph. you are getting lift off det and yes it could do damage. running a scooby z4 ecu past at speeds you described is not a good idea IMO.
Reply
Old Apr 20, 2009 | 11:09 PM
  #10  
The Rig's Avatar
The Rig
Thread Starter
Scooby Regular
20 Year Member
iTrader: (13)
 
Joined: Dec 2002
Posts: 7,891
Likes: 8
Default

yeah,luckily its not often so at the mo,cant justify the £400+ for ecu/remap

cheers
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
KAS35RSTI
Subaru
27
Nov 4, 2021 07:12 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
Dec 28, 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
Nov 18, 2015 07:03 AM
shorty87
Subaru Parts
1
Oct 7, 2015 11:52 AM
Ganz1983
Subaru
5
Oct 2, 2015 09:22 AM


Thread Tools
Search this Thread

All times are GMT +1. The time now is 11:12 AM.