I have a defi set-up in my car - have oil pressure/boost/fuel pressure - the works.
Only had the car for about 3 weeks and yesterday needed to change the stereo. Since doing so my gauges have gone a little haywire (to say the least).

Whilst driving everything is pretty much as it should be - however, if I boost, the boost gauge gets to 1 and bleeps and the red light comes on. If you let the revs drop below 1k (idling) the Oil Pressure gauge beeps and the red light comes on!

Been looking online and have found how to install a system - but nothing on how to programme it (does it even need programming). Anyone got any knowledge of these - would be VERY much appreciated

 

When you changed the stereo i assume you disconnected the battery and so the defi-link controller went back to it's pre-sets, trying to find my instructions now

 

Would love VERY much for you to find the instructions LOL - however, when the stereo was put in - the battery WASN'T disconnected
Although - the other half said when he pushed the stereo back in that there was a beeping noise - but he did disconnect a LIVE wire from somewhere

 

OK sounds like the Defi live was taken from the stereo live as they don't take much power, will get back to you as soon as i can

 

no big deal mate!!!!
need to preset the warning parameters....

 

Press "warning set" on the controller, then adjust values with "up" and "down" keys on same, press warning set" to toggle between meters. When happy just let be for a few seconds.

IIRC