How to fit Knock sensor
#1
How to fit Knock sensor
Hi i want to fit a new knock sensor on car but have not got a clue where to start!
Could someone please tell me if it is an easy enough job to do by myself and where it ia actually situated it is a 99 type r.Cheers
Could someone please tell me if it is an easy enough job to do by myself and where it ia actually situated it is a 99 type r.Cheers
#2
Scooby Regular
iTrader: (1)
Easy enough to do - remove TMIC,disconnect knock sensor connector and undo the 12mm headed bolt holding the knock sensor to the block.
Torque setting for knock sensor bolt is 24Nm when refitting.
Diagram below is for an earlier version but they are all located in the same place
Mick
Torque setting for knock sensor bolt is 24Nm when refitting.
Diagram below is for an earlier version but they are all located in the same place
Mick
Thread
Thread Starter
Forum
Replies
Last Post
aaron_ions
General Technical
17
03 November 2021 11:07 AM
charlesr
General Technical
9
28 September 2015 09:16 AM
aaron_ions
General Technical
1
17 September 2015 10:42 AM