hi,
just fitted the V-flow injectors from mark at lateral to my project RS200 IMPREZA, and just checking they are fitted correctly,

i removed the rails and fitted the washer with the black side up under the O-ring in the inlet manifold, put the O-RING back in and fitted the rails with the injectors in,

just checking the washer with the black side up is in the correct place,
cheers phil.

 

Hi, yes Black side up. The washer should be pushed down inside the middle of the Black o ring, to make sure it's centralized.


Mark.

 

a up mark, i took out the O-ring and put the washer under it, is that ok? would they have tightend down to the right place,
phil.

 

The washer is designed to be a snug fit in the middle of the o ring. This is to make sure it sits centrally. If you have already re-fitted the rails/ injectors, I assume they all went back ok ?

If not, I would re-fit them as I have suggested.

 

thanks, i think ill just whip them back off then and fit them in the recess that runs in the middle of the O-ring, thanks again.
phil.