oil catch tank system
29 January 2009, 08:31 AM
#1
Scooby Regular
Thread Starter
Join Date: Jun 2004
Posts: 383
Likes: 0
Received 0 Likes
on
0 Posts
oil catch tank system
i am doing a rebuild and once complete i'm going to fit a catch tank.
i was looking at the block and the standard breather system, i saw that the crank breather is connected to the manifold just under the main air inlet.
it seems to be a 1 way valve, can this be blanked off, or do you leave it free or will it need plumbing in to the new system??
the car is a my99 v5 type r
thanks
simon
i was looking at the block and the standard breather system, i saw that the crank breather is connected to the manifold just under the main air inlet.
it seems to be a 1 way valve, can this be blanked off, or do you leave it free or will it need plumbing in to the new system??
the car is a my99 v5 type r
thanks
simon
30 January 2009, 08:10 AM
#6
Scooby Regular
Join Date: Sep 2007
Location: Stockholm, Sweden
Posts: 239
Likes: 0
Received 0 Likes
on
0 Posts
It's a one way valve 
when off boost crank gases goes in there, when on boost pcv valve closes and crank gases goes into induction-pipe and then via turbo & IC to manifold.
when off boost crank gases goes in there, when on boost pcv valve closes and crank gases goes into induction-pipe and then via turbo & IC to manifold.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM