Advice on changing rear box
#1
Scooby Regular
Thread Starter
Join Date: May 2007
Location: peterborough
Posts: 451
Likes: 0
Received 0 Likes
on
0 Posts
Advice on changing rear box
Hi i want to change my rear box but after looking i have a 3in bore going into the box i have at the mo.
i was wondering if it is possible that i can fit a 2.5in rear box to the 3in centre pipe.
it is not a bolt on unit it is a sleaved unit and have been offered a 2.5in rear box.
any help would be great.
i was wondering if it is possible that i can fit a 2.5in rear box to the 3in centre pipe.
it is not a bolt on unit it is a sleaved unit and have been offered a 2.5in rear box.
any help would be great.
#2
Scooby Regular
iTrader: (5)
is your current 3" piping sleeve fit as well?
If so, you can get a 3" -> 2.5" reducer from jetex (http://www.jetex.co.uk).
If so, you can get a 3" -> 2.5" reducer from jetex (http://www.jetex.co.uk).
#3
Scooby Regular
Thread Starter
Join Date: May 2007
Location: peterborough
Posts: 451
Likes: 0
Received 0 Likes
on
0 Posts
i have a 3in centre section that is sleaved to the rear box and wanted to see if it is possible to use a 2.5in rear box with out any problems.
cheers
cheers
#4
Scooby Regular
iTrader: (5)
Look here: Jetex Custom Exhaust Parts - Build your own custom design for road, race or rally use...
About halfway down there's a "stepped sleeve". You might be able to use that
About halfway down there's a "stepped sleeve". You might be able to use that
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
20
22 October 2015 06:12 AM