Injector install advice
#1
Injector install advice
Hi,
I am in the process of changing my STI8 Injectors. I have a set of 650cc Power Enterprise injectors.
I starte on the passenger side, i removed the old injectors and installed the new ones. I found that the PE injectors do not sit at the same angle as the oe injectors, they sit slightly upright!!
I installed the injectors and switched the ignition on and off a few times to prime the fuel pump,there were no leaks!
Will switching the ignition on and off pressurise the fuel rail/injectors? Or do i have to start the engine to make the injectors flow?
Thanks
I am in the process of changing my STI8 Injectors. I have a set of 650cc Power Enterprise injectors.
I starte on the passenger side, i removed the old injectors and installed the new ones. I found that the PE injectors do not sit at the same angle as the oe injectors, they sit slightly upright!!
I installed the injectors and switched the ignition on and off a few times to prime the fuel pump,there were no leaks!
Will switching the ignition on and off pressurise the fuel rail/injectors? Or do i have to start the engine to make the injectors flow?
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
hedgecutter
General Technical
3
25 September 2015 02:35 PM