Hi folks

Mate has a "L reg" (think it's 94) Estate Import. I can't find a data link connector because I don't think it has one? The Engine light comes on after about 10mins driving and I need to know how to extract the faults from the ECU. Is there some "blink code" method?

Thanks in advance.

 

have a look under help pages

Simon

 

Thanks very much Simon

 

no problem

 

will this reset clear a recurrent CEL?

 

you need to read the error code

then reset, if it domes bacvk then it needs fixing

 

removed the EGT sensor when I upgraded my uppipe, going down the 2K ohm resistor MOD, has been fine for a week (cleared by garage last week) came back on today

 

Hi Folks

The car produced 2 Faults:-

1. Oxygen Sensor - I assume this is the Lambda Senor?

2. Pressure Sensor/Pressure Exchange Solenoid Valve

Can anyone point me in the direction of a parts supplier?

Thanks

 

Anyone.........please?

 

sorry mate

 

firstly reset the ecu and see if they reoccur.. they could be old and no longer valid.

the oxygen sensor if it reoccurs needs replacing..

the pressure sensor/pressure exchange solenoid valve error code could be for a few reasons.. firstly are you running a boost controller?
also check the pipe work on the inner drivers side wing. . all of the vac lines should plug in somewhere etc.. check none have come off..

Simon