0.5 bar of boost
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: May 2008
Posts: 501
Likes: 0
Received 0 Likes
on
0 Posts
0.5 bar of boost
when i bought my wrx it had a boost gauge but wires where not conected i conected the wires and it came on but when i took it out to try it it only regestering 0.5 bar of boost the pipe has had a t conector in to the pipe from the actuator on the turbo is that correct any ides why my car would only be running at 0.5 bar instead of 0.9 bar
#2
Former Sponsor
iTrader: (3)
My first port of call would be to see if the gauge was right....
A good way to check is to get it on a rolling road near you and get them to measure boost as well as give you power figures (and checking fueling).
This will also serve as a good baseline for any future modifications so wont be money wasted.
I dont know what area you are in but I use Zen performance in Northampton as Paul's dyno set up is very good
A good way to check is to get it on a rolling road near you and get them to measure boost as well as give you power figures (and checking fueling).
This will also serve as a good baseline for any future modifications so wont be money wasted.
I dont know what area you are in but I use Zen performance in Northampton as Paul's dyno set up is very good
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM