What power should i expect?
27 August 2008, 03:08 PM
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Jun 2007
Location: Cyprus
Posts: 170
Likes: 0
Received 0 Likes
on
0 Posts
What power should i expect?
My car is a jdm sti my06, currently running 323.5 ps and 439NM with aTrust pe2 catback exhaust, an sti panel filter and a remap...
My next mods are going to be a SYMS downpipe(decat) and an AVC-R boost controller and a walbro 255 fuel pump and Tomei Expreme Headers along with a new remap...
What power should i expect from this and what torque?
thanks,
Charis
My next mods are going to be a SYMS downpipe(decat) and an AVC-R boost controller and a walbro 255 fuel pump and Tomei Expreme Headers along with a new remap...
What power should i expect from this and what torque?
thanks,
Charis
Last edited by charis_sti; 08 September 2008 at 01:25 AM.
08 September 2008, 01:30 AM
#3
Scooby Regular
iTrader: (3)
Join Date: Aug 2000
Location: 1600cc's of twin scroll fun :)
Posts: 25,565
Likes: 0
Received 2 Likes
on
2 Posts
Keep the Subaru equal length headers, i dont know anyone who makes them as good as the standard item 
but a full decat and remap will see you about 360bhp and similar torque
Tony
but a full decat and remap will see you about 360bhp and similar torque Tony
08 September 2008, 12:09 PM
#5
Scooby Regular
iTrader: (15)
Join Date: Jul 2001
Location: Portsmouth
Posts: 8,606
Likes: 0
Received 0 Likes
on
0 Posts
its not the equal length bit Tony was referring to, he was suggesting that the oe item is top notch quality and unlikely to crack and cause you bother later down the line
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM