turbo timer harness/loom?
02 August 2008, 09:41 AM
#1
Scooby Regular
Thread Starter
Join Date: Apr 2007
Posts: 52
Likes: 0
Received 0 Likes
on
0 Posts
turbo timer harness/loom?
Hi, Im looking to fit a turbo timer into my classic wrx on a N plate..
taken off the surround for the steering column to expose the wires and various plugs- however unsure which one i should be plugging the loom into? I know you're meant to unplug an exist one, and fit the turbo timer "in between" as such- using the two plugs on the loom- however cant seem to find which one it is.
Any help would be apreciated! THanks
taken off the surround for the steering column to expose the wires and various plugs- however unsure which one i should be plugging the loom into? I know you're meant to unplug an exist one, and fit the turbo timer "in between" as such- using the two plugs on the loom- however cant seem to find which one it is.
Any help would be apreciated! THanks
02 August 2008, 11:44 AM
#4
Scooby Regular
Join Date: Jul 2007
Location: dundee
Posts: 667
Likes: 0
Received 0 Likes
on
0 Posts
it goes on the wires that come from the back of the ignition barrel, it might help to take the plastic of thats in the footwell, follow the leads from the barrel,is there a blue connecter on it anywhere?
02 August 2008, 03:01 PM
#5
if you got the harness with the turbo timer all you need to do is take off the plastic trim above the pedals, you'll see a few connectors sitting under the steering column, just unplug them one by one until you find the one the timer harness fits into. it will be a 4 wire plug your looking for and the wires into it will be pretty thick too.
02 August 2008, 03:51 PM
#6
mine connects to a black block with 6 pin holes for wires but only has 4 of the pins being used, the 4 wires are all black but one has a green stripe,one has a yellow stripe and one has a blue stripe the other is plain black. you should just be able to plug and play unless your timer has a second earth wire coming out the unit you need to earth?
i'll post a pic in a mo
i'll post a pic in a mo
Trending Topics
05 August 2008, 11:00 AM
#9
Scooby Regular
Thread Starter
Join Date: Apr 2007
Posts: 52
Likes: 0
Received 0 Likes
on
0 Posts
05 August 2008, 01:29 PM
#11
Scooby Regular
Thread Starter
Join Date: Apr 2007
Posts: 52
Likes: 0
Received 0 Likes
on
0 Posts
i heard theres a nipple where i can put the vacuum pipe onto without using a t-piece which is handy. you know where this is located? And which grommet to take it through..? plz refer to my other post in same section calld "boost gauge/oil pressure gauge" .. cheers fella 
Thread
Thread Starter
Forum
Replies
Last Post