New front crank seal - still leaking
#1
Scooby Regular
Thread Starter
Join Date: Jul 2001
Location: Telemark, Norway
Posts: 326
Likes: 0
Received 0 Likes
on
0 Posts
New front crank seal - still leaking
Oil was leaking from underneath the oil pump and on to the manifold, so I changed the front oil crank seal. But now the leak is even worse... I didn't change the O-ring behind the oil pump, could this cause similar problems?
Or is my engine simply worn out, causing blowby? It only reaches 4.1 bar@100 degc oil temp, no matter what rpm. 127.000 miles, used as a track day toy since new.
Or is my engine simply worn out, causing blowby? It only reaches 4.1 bar@100 degc oil temp, no matter what rpm. 127.000 miles, used as a track day toy since new.
#3
Scooby Regular
iTrader: (1)
There is an "O" ring between the pump and block face but the oil pump back plate screws might have come loose and leaking from there - quite common to happen.
If it has been used as a track day tool from new then its a fair chance you will have excessive blow-by. Get a cylinder leak down test and a Compression test done to see what the Internal health of the engine is.
Mick
If it has been used as a track day tool from new then its a fair chance you will have excessive blow-by. Get a cylinder leak down test and a Compression test done to see what the Internal health of the engine is.
Mick
Thread
Thread Starter
Forum
Replies
Last Post
shorty87
Full Cars Breaking For Spares
19
22 December 2015 11:59 AM