LM1 hook up with Power FC
#1
Scooby Regular
Thread Starter
iTrader: (9)
Join Date: Aug 2005
Posts: 790
Likes: 0
Received 0 Likes
on
0 Posts
LM1 hook up with Power FC
I got bad readings from my widebandlambda (LM1) to the Apexi Power FC connected via Datalogit.
The numbers are much leaner than showing on the LM1.
Now I hooked up averything to another laptop and get no readings at all.
But I wired the AUX input the same way I did last time.
Here is the manual I read and did as shown. LC-1 Integration into Apex Power FC w/Dataloggit Logger:: Innovate Motorsports Application Notes
What would I have to do, to use both AUX outs from the LM1 to minimize outputdifferences?
I only connected the AN1 with the red cable from the LM1 and used AN2 for ground. White one from the LM1 is not used at all.
Help needed please!!!
The numbers are much leaner than showing on the LM1.
Now I hooked up averything to another laptop and get no readings at all.
But I wired the AUX input the same way I did last time.
Here is the manual I read and did as shown. LC-1 Integration into Apex Power FC w/Dataloggit Logger:: Innovate Motorsports Application Notes
What would I have to do, to use both AUX outs from the LM1 to minimize outputdifferences?
I only connected the AN1 with the red cable from the LM1 and used AN2 for ground. White one from the LM1 is not used at all.
Help needed please!!!
#2
Scooby Regular
Thread Starter
iTrader: (9)
Join Date: Aug 2005
Posts: 790
Likes: 0
Received 0 Likes
on
0 Posts
Now it worked, seems as the problem was the powersupply I used with the other laptop, as the battery was not working!
Now without using a powersupply from the car it shows the correct and matching numbers as on the LM1!
Now without using a powersupply from the car it shows the correct and matching numbers as on the LM1!
Thread
Thread Starter
Forum
Replies
Last Post