found a brokem wire earlier, its black and yellow and comes out around the same place as the air con drain at the bottom of the bulkhead.
Anyone know what it,s for?

 

????????????

 

Black with yellow stripe are usually Earth to chassis wires. May have corroded and then vibration has caused it to come away from mounting point.
Kevin

 

could this bring up either fault code 24 or 33?

The wire is a very small diameter

 

could this be for the speed sensor?

 

does it actually come out of the air con drain?

if it does then i would hazard a guess and say it is not factory fit and has been routed in for something else at some point in its life,as i doubt subaru would route a wire through the drain tube.

 

No it looks as if its the gromit next to it

 

in that case is it possible to see the other end of it?

it may be for the neutral sensor i think that is down there somewhere not 100% but someone may be able to confirm?

 

would that give me a speed sensor fault? don't know where the other end goes