WRXMATT

Please look at these and tell me what i need to fit a standard air box.

I notice the MAF is set in the round plastic pipe, is this normal?

I think i will need to extend the pipe a bit to reach an airbox.

Is the metal bent piece of pipe standard?

http://i278.photobucket.com/albums/k...t/Image009.jpg
http://i278.photobucket.com/albums/k...t/Image012.jpg
http://i278.photobucket.com/albums/k...t/Image011.jpg
http://i278.photobucket.com/albums/k...t/Image008.jpg

The air filter on it is just a shell with some tights pulled over it, i'm not using the car until i've got a proper set up so i need this info urgently.

Thanks
Matt

WRXMATT

Oh sorry, 2 of the pics are of a hose on the back right side of the engine (as you look at it from the front of the car) below the intercooler.

I noticed this pipe is blocked off, why would this be?

It does have a bailey dump valve fitted, could this be the reason?

Thanks

tezza43

who sold you a car with tights on it i would not have touched it could do real damage to your maf mate where are you in hampshire ?

WRXMATT

I know i was an idiot lol. Not in hampshire any more.

I did by this as a second car and a bit of a project, could turn out to be a big project haha

c_maguire

The cut off red Samco pipe would normally be a c-shaped pipe that comes up to connect to the OE recirc dump valve.
The plastic pipe with your MAF sensor in looks to be the original part removed from the standard airbox. The short metal section looks to have been made up by whoever fitted the cone.
Kevin

WRXMATT

Many thanks Kevin, usefull information.

Hopefully i'll get hold of a standard air box soon and i should be able to extend the pipe to it

Matt