1st graphs of power run using datalogit
Thread Starter
Scooby Regular
Joined: Dec 2006
Posts: 743
Likes: 0
From: sunny north east
1st graphs of power run using datalogit
well all seems good: Ive got the datalogit running with FC-edit and an LM-1 wideband AFR
done a bit of tweaking to lower the AFR at mid revs WOT. but other than that and a bit playing I havent really done much else...just trying to get used to the software
nice level boost (though I only get full 1.2bar from 4100rpm) and the 440cc jectors are maxing at 84% in 3rd gear at just shy of 7k rpm
(car showed 300bhp and 290lb/ft on a dyno...this is on a .....'private' road
thoughts?
done a bit of tweaking to lower the AFR at mid revs WOT. but other than that and a bit playing I havent really done much else...just trying to get used to the software
nice level boost (though I only get full 1.2bar from 4100rpm) and the 440cc jectors are maxing at 84% in 3rd gear at just shy of 7k rpm
(car showed 300bhp and 290lb/ft on a dyno...this is on a .....'private' road
thoughts?
Thread Starter
Scooby Regular
Joined: Dec 2006
Posts: 743
Likes: 0
From: sunny north east
I was wondering what igintion advance you guys have at full chat?
mine sits around 22 degrees which seems quite well advanced, but I dont get any issues (knock/temps etc.)
any mappers out therre have any thoughts?
mine sits around 22 degrees which seems quite well advanced, but I dont get any issues (knock/temps etc.)
any mappers out therre have any thoughts?
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
38
Jul 17, 2016 10:43 PM
StueyBII
Engine Management and ECU Remapping
5
Sep 22, 2015 02:13 PM
matt12
ScoobyNet General
64
Sep 16, 2015 09:16 PM
matt12
Engine Management and ECU Remapping
4
Sep 14, 2015 09:36 AM
