jus wanna make sure im doin this properly. connect black to black and green to green wires. turn on press accellerator down then return to half way and hold for a few seconds.. release pedal. turn the ignition on and go for a drive without boosting it until warm. after this point will the engine light appear to say its reset?

 

info here

Simon

 

OK PROBLEM...so i connected all the wires turned the key..put the accellerator down then at half way for 2 secs then released it - while the key was turned i cud hear a clicking wining noise and the fans wre going on then off?! weird. turned the ignition on and the engine light didnt come on or pulse. do i need to drive it until warm (only quarter way up in temp at the mo) and then the ecu resets?

 

problem sorted....reset the ecu after driving it for 2 mins. came back disconnected all wires the reconnected black wires and no fault appearing! is that the end of it all now?! seems to be running well

 

the fans etc and relays is the test mode and you will get it when reseting etc

I presume you had a recorded error code before?

probably antoher thread?

if the problem doesn't reoccur then it could have been a one off blip etc..

Simon