hey guys...got the engine out & got everything off it,so going to split it tommorow but just looked at the manual & it says i need a tool to get piston pins out what is this tool,where can i get 1 or could i use some thing else

thanx marv

 

if you have taken the bungs out of the block two on the two on the rear one under inspection plate you need to take out the circlips and use an bar with a little hook on the end to pull the gudgeon pin out just don't mix them up from piston to piston there is demonstration on you tube somewhere showing how to do it hope this works? .YouTube - pulling pistons out of Subaru block

 

thamks mate yeah that's helped no end

 

your welcome!