bugeye side light bulbs
Thread Starter
Scooby Regular
iTrader: (11)
Joined: Mar 2006
Posts: 12,613
Likes: 9
From: Browsing through a copy of Razzle
how the hell do you get them out to change them
ive changed my headlight bulbs today and can i get the side lights out,can i buggary
anyone help me
ive changed my headlight bulbs today and can i get the side lights out,can i buggary
anyone help me
No, as far as I remember it is just three bolts. Two on top and one on the side by the grill. I think they are 10mm but just try a spanner. You can get access by removing the battery and air box, but I think its easier taking the headlight out. Removing the unit is Subaru's advice when contacted. Shouldn't take too long now
Thread Starter
Scooby Regular
iTrader: (11)
Joined: Mar 2006
Posts: 12,613
Likes: 9
From: Browsing through a copy of Razzle
thanks mate,ive tried doing it by removing the airbox but its immposable theres no way of getting to the sidelight
also to the right of the light unit there is a small piece of trim..i take it this needs to be removed to access the bolt near the grill
also to the right of the light unit there is a small piece of trim..i take it this needs to be removed to access the bolt near the grill
I found it easiest to just take the whole headlight unit out.
1) Remove the air intake: undo the two bolts where it is held onto the front bulkhead, then lift it up and out. Obviously this is only necessary for the driver's side.
2) Remove the grille: there are two clips at the bottom (use a long flat screwdriver) and four at the top. The clips are fragile!
3) Remove the side inserts by releasing the three clips on each: two on the top and one on the inside edge. The plastic insert then slides forwards.
4) Remove the headlight unit: there are three bolts (one on the top and two on the inside flange behind where the inserts were), plus a stiff push-in pin hidden behind the outer edge. Once the three bolts are out you will need to pull the whole unit forward strongly but slowly. Keep it straight. Make sure you have one hand on the outside edge of the unit. The pin can be VERY stiff, as it tends to corrode.
Whole process takes about five to ten minutes with practice.

M
1) Remove the air intake: undo the two bolts where it is held onto the front bulkhead, then lift it up and out. Obviously this is only necessary for the driver's side.
2) Remove the grille: there are two clips at the bottom (use a long flat screwdriver) and four at the top. The clips are fragile!
3) Remove the side inserts by releasing the three clips on each: two on the top and one on the inside edge. The plastic insert then slides forwards.
4) Remove the headlight unit: there are three bolts (one on the top and two on the inside flange behind where the inserts were), plus a stiff push-in pin hidden behind the outer edge. Once the three bolts are out you will need to pull the whole unit forward strongly but slowly. Keep it straight. Make sure you have one hand on the outside edge of the unit. The pin can be VERY stiff, as it tends to corrode.
Whole process takes about five to ten minutes with practice.

M
Last edited by _Meridian_; Jan 12, 2008 at 11:04 PM.
Thread
Thread Starter
Forum
Replies
Last Post
MH-Racing
Subaru Parts
18
Oct 18, 2015 04:49 PM
TylerD529
Lighting and Other Electrical
5
Sep 20, 2015 12:10 PM




