Guage of Vacuum Hosing
#1
Scooby Regular
Thread Starter
Join Date: Jun 2005
Location: Hampshire
Posts: 1,579
Likes: 0
Received 0 Likes
on
0 Posts
Guage of Vacuum Hosing
I need to change the vacuum hosing running from the boost solenoid to the actuator and the compressor housing to the boost solenoid.
What guage or internal diameter is this tubing and does the Apexi AVCR use silicon tubing.
thanks
What guage or internal diameter is this tubing and does the Apexi AVCR use silicon tubing.
thanks
#2
Scooby Regular
Join Date: Dec 2006
Location: at the petrol station again!!!
Posts: 1,213
Likes: 0
Received 0 Likes
on
0 Posts
from memory i think it is 3mm but stand to be corrected if wrong.
i was told best not to use silicone hose as it goes soft when hot and can collapse although i had it on mine for a while until i got rubber and did not encounter any probs?
#5
Scooby Regular
Join Date: Oct 2007
Location: A small small island...about 4th gear!
Posts: 111
Likes: 0
Received 0 Likes
on
0 Posts
As dynamix says 4mm at actuator on standard turbo. then if im not mistaken you have to go to 6mm at AVCR solenoid. Usually get a plastic reducer with the AVCR kit.
Hope this helps
Hope this helps
Thread
Thread Starter
Forum
Replies
Last Post
Pro-Line Motorsport
Car Parts For Sale
2
29 September 2015 07:36 PM
Pro-Line Motorsport
Car Parts For Sale
0
27 September 2015 11:19 AM