*4real

Hi Guys , i have just fitted my blitz boost controller and adjusted it to 1.5bar of boost when i put my foot down its fine it goes 1.5 but if i keep it down i loose all boost ???

when i attached the boost controoler pipe to the actuator and turbo the spare pipe i capped?? should i have done this i own an 03 wrx by the way could somebody help, car runs perfect when put on 1.2 bar andy more i struggle!!

AlanPPP

iTrader: (2)

Fuel cut by the sounds of it mate.Lower the boost.

burt2000

iTrader: (1)

^^^ as alan says 1.5 bar is too high, boost cut is around 1.2 iirc, id be turning it down asap

*4real

Thanks guys i though you could run 1.5 comfortabley as if you get a remap would that not increase boost to 1.6 as i was advise by ecutek engineer??

petedotuk

that really depends on who re-maps ur car mate.

most ppl only goto 1.2 and only a handful in the whole UK take it to 1.5/1.6.

Jolly Green Monster

iTrader: (4)

1.5bar is well ott for td04 turbo fitted to the 03 wrx...

you need it mapped to run 1.2bar safely