does anyone know the correct boost preasure for the sti version 2 1995 it had a bleed valve on it and was over boosting so i screwed it right out and now its only boosting to 0.8 its a new car for me so i dont want to blow it up so if anyone could give me the correct setting i would be happy cheers

 

0.8 is standard I think..............

 

13.64psi / 0.95bar (approx)

 

How about removing the bleed valve thing completly. At least you'll know it's not fecking up your boost level.

Damien

 

thought sti jdm was 1.2 bar .but might be wrong .mines a 95 wagon wrx (not sti)jdm and that on standard boast is 0.8

 

0.8 bar is about right

 

STi Version 2 will be running a 6K ECU as per the STi 555 V-Ltd (same car but blue).

Mapped to run 13.64psi/0.95bar boost as standard.

It depends how the bleed valve is plumbed regarding what boost it will run with it closed.
Personally I would remove it and ensure the boost control solenoid is plumbed as below :


If it doesn't run the correct boost after that then the bleed valve may of been fitted to mask a faulty boost control solenoid or a car running in limp home / safe mode