Cambelt and induction kit questions ?
#1
Scooby Regular
Thread Starter
iTrader: (6)
Join Date: Jan 2007
Location: Gloucestershire
Posts: 2,541
Likes: 0
Received 0 Likes
on
0 Posts
Cambelt and induction kit questions ?
Before I fit my STI RA engine into my WRX i'm going to put a new cambelt on it. Can anyone give me a guide on how to do this ?
I'm going to be fitting either a TD05 18g or 20g turbo which means it'll be front entry. What induction kit should I get and will that come with all the pipes etc that i'll need.
I'm aiming for around 360-400bhp,will I need to change the MAF as i've heard the standard one can't handle the airflow over a certain amount ?
I'm going to be fitting either a TD05 18g or 20g turbo which means it'll be front entry. What induction kit should I get and will that come with all the pipes etc that i'll need.
I'm aiming for around 360-400bhp,will I need to change the MAF as i've heard the standard one can't handle the airflow over a certain amount ?
#3
Scooby Senior
Pics are clicky
You may need manifold spacers if you are to use the samco inlet hose under the manifold
Not too sure on the induction kit or Maf, IIRC 911 (Graham) is running approx 380-400 on the std MAF with a 20G though
#4
Scooby Regular
Thread Starter
iTrader: (6)
Join Date: Jan 2007
Location: Gloucestershire
Posts: 2,541
Likes: 0
Received 0 Likes
on
0 Posts
Are those instructions from a cd or something ? If so,where can I get one from ? The pictures come up a bit small to see properly !
I'm planning on fitting the manifold spacers anyway. Do you know what the part number is for the samco inlet hose ? I'm going to Trax @ Silverstone next weekend so will hopefully get one from there.
Thread
Thread Starter
Forum
Replies
Last Post