cylinder head unbolting sequence?
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Aug 2005
Location: Manchester ish
Posts: 18,547
Likes: 0
Received 0 Likes
on
0 Posts
cylinder head unbolting sequence?
I know there usually is a sequence for torqueing head bolts down but is there a sequence for unbolting them to remove the heads from the block.
Engine is a phase 1 with hydraulic tappets
Cheers
Engine is a phase 1 with hydraulic tappets
Cheers
#3
Former Sponsor
Join Date: Dec 2005
Location: 10.68 QT mile in 2007 2.33 Type R ** Current 2002 Spec C 2.33 Track prepped.
Posts: 1,658
Likes: 0
Received 0 Likes
on
0 Posts
No it’s best you should release the tension evenly going from opposite bolts ideally following the same pattern.
Turn each bolt half turn at a time and so on increasing the turns as the tension is released. Once the head is free then take the bolts out one by one.
Turn each bolt half turn at a time and so on increasing the turns as the tension is released. Once the head is free then take the bolts out one by one.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM