New steering wheel, air bag issue!
#1
Scooby Regular
Thread Starter
New steering wheel, air bag issue!
Just fitted a new steering wheel but the airbag light is stuck on now.. I'd already had the original wheel off to test fit this one, turns out I needed to make some modfiications to increase the clearence.. Anyhoo I've wired it up (matched up the yellow/blue, yellow/black and green/white wires) but when I reconnect the battery and turn on the ignition the airbag light doesnt go out
What in gods name have I done wrong
What in gods name have I done wrong
#3
Scooby Regular
Thread Starter
The original wheel had two plugs. one large yellow one and one smaller white one, the yellow one had the three wires for the airbag and the smaller one had three wires but only one was used for the horn:
The new wheel has one small brown plug with four wires. 3 for the airbag and 1 (green red) for the horn.
The new wheel has one small brown plug with four wires. 3 for the airbag and 1 (green red) for the horn.
#5
Scooby Regular
Thread Starter
What I have also noticed is the Squab has a 2 pin connector that goes to somre more electronics housed in the back of the wheel which has the connector with the three wires (yellow/blue, yellow/black, green/white)....
What also adds to the confusion is the wheel is stamped 1997 inside.. my car is a 97 model and its has completely different connectors!
What also adds to the confusion is the wheel is stamped 1997 inside.. my car is a 97 model and its has completely different connectors!
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
Mattybr5@MB Developments
Full Cars Breaking For Spares
20
22 October 2015 06:12 AM