Can anyone help?? My auto to manual gearbox conversion, throwing up CEL.
#1
Scooby Regular
Thread Starter
Join Date: Dec 2006
Location: Oxford- the shire
Posts: 1,281
Likes: 0
Received 0 Likes
on
0 Posts
Can anyone help?? My auto to manual gearbox conversion, throwing up CEL.
My MY94 wrx started life as an auto (sa model) , was converted to 5spd manual by previous owner, at any random time when driving, although seems to happen most when after higher speed cruising i am slowing down, the cel appears and i can get rid of it buy just holding clutch down and letting off the throttle for a few seconds and it just goes out, so in effect returning engine to idle. The CEL code is 51- neutral position switch, any ideas how i can stop this without having to change all the ecu's (auto ecu etc) and loom etc?
thanks
thanks
#5
Scooby Regular
Join Date: Apr 2007
Location: East Sussex - www.polarperformance.co.uk
Posts: 359
Likes: 0
Received 0 Likes
on
0 Posts
Does it have a neutral position switch fitted to the wiring harness ?
It may of been removed when the box was swapped, so it could be worth getting on strapping it somewhere and connecting it up.
It may of been removed when the box was swapped, so it could be worth getting on strapping it somewhere and connecting it up.
#6
Scooby Regular
Thread Starter
Join Date: Dec 2006
Location: Oxford- the shire
Posts: 1,281
Likes: 0
Received 0 Likes
on
0 Posts
Good shout scott, i have not got a clue where i might find the sensor, or where it might come off the harness? Anyone shed any light on this please?
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post