gavs scooby

hi guys can someone tell me within the next 30 miutes(19:48 at the minute)if a 95 wrx engine will fit into a 99 uk car. wiring loom and plugs and things
thanks

Chriso2.5

you would need to use the inlet manifold off your car because the idle valve is in a different place, your version has a single coil pack unit and i think some of the breathers are in a different place on the older inlet manifold.

not 100% sure if all the sensors are in the same place though on the block but i think they are.

andy97

iTrader: (1)

phase 1 into phase 2 Doubt it would be straight forward

jaytc2003

iTrader: (1)

fit yes, run not straight away without swapping things over

p1prodrive

iTrader: (3)

buying off ebay ?...lol

500

You will need to swap cylinder heads too, bit late now though