Notices
General Technical
Sponsored by:
Sponsored by: CARiD

car wont start and 3 error codes :S

Thread Tools
 
Search this Thread
 
Old Jun 16, 2007 | 11:27 PM
  #1  
DAVE26's Avatar
DAVE26
Thread Starter
Scooby Regular
 
Joined: Aug 2000
Posts: 2,060
Likes: 0
From: Leeds
Default car wont start and 3 error codes :S

hi guys n gyals

had a 10 min drive to my bro's tonight
had a little race on the way like ya do

was in his house less than a min
then when i came back to the car it wasnt even turning over
i joined black connector and it threw 3 codes back at me
22
23
24

22 im sure is knock sensor
23 is mass air flow i think
24 im not too sure about

im sure the mass air and knock are stored in the ecu from a while back when i forgot to plug them back in upon rebuild.
the 24 im not too sure about
any1 got any ideas as to the cause and to the remedy ?

i went back into my bro's for a torch, 5 mins later i came back to the car and it fired straight up ?!?!?

the car is a my99 turbo with a 2004 engine in.

thanks for any help

dave

Last edited by DAVE26; Jun 16, 2007 at 11:29 PM.
Reply
Old Jun 16, 2007 | 11:38 PM
  #2  
Jolly Green Monster's Avatar
Jolly Green Monster
Former Sponsor
iTrader: (4)
 
Joined: Jan 2001
Posts: 16,548
Likes: 2
From: ECU Mapping - www.JollyGreenMonster.co.uk
Default

wasn't turning over?? ie. the key just turned and nothing happened?

if so.. immobiliser, start jammed, battery low or battery connection lose..

Simon
Reply
Old Jun 17, 2007 | 12:34 AM
  #3  
DAVE26's Avatar
DAVE26
Thread Starter
Scooby Regular
 
Joined: Aug 2000
Posts: 2,060
Likes: 0
From: Leeds
Default

hi simon
yes nothing there
immob wasnt on i made sure by arming and disarming.
battery connection on tight too
starter never gave me problems b4 but could be possible
but made no noise at all apart from teh fan turnign on for some strange reason ?!?!?

dave
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Iqy7861
Engine Management and ECU Remapping
22
Oct 12, 2015 09:21 AM
ossett2k2
Engine Management and ECU Remapping
15
Sep 23, 2015 09:11 AM
ossett2k2
General Technical
9
Sep 13, 2015 09:35 AM
blackandz
General Technical
0
Sep 12, 2015 07:01 PM
alcazar
Other Marques
9
Sep 9, 2015 05:42 PM




All times are GMT +1. The time now is 06:55 AM.