Notices
General Technical
Sponsored by:
Sponsored by: CARiD

Diagnostic Mode not working

Thread Tools
 
Search this Thread
 
Old Jun 3, 2007 | 08:12 PM
  #1  
MJBritton25's Avatar
MJBritton25
Thread Starter
Scooby Newbie
 
Joined: May 2006
Posts: 23
Likes: 0
Default Diagnostic Mode not working

Hi, I have a 96 import WRX.
A few days ago, the engine cut out and it refuses to start, The starter motor is turning over but plugs arent sparking. Check Engine light has never appeared. Connected the two black clips to put it in diagnostic mode, but check engine light will not appear. Tested CEL bulb - its fine, but I swapped it anyway just to make sure.
Ive also replaced the crankshaft sensor. Fuel pump is also ok.

So, no engine firing and no diagnostics.

Knackered ECU ? Any other ideas ?
Reply
Old Jun 5, 2007 | 02:08 PM
  #2  
MJBritton25's Avatar
MJBritton25
Thread Starter
Scooby Newbie
 
Joined: May 2006
Posts: 23
Likes: 0
Default

Problem was main fuse to ECU was blown. Replaced this and ECU diagnostics fine. Reason the main fuse was blown - one of the ignition coils had melted.
Reply
Old Jun 5, 2007 | 03:22 PM
  #3  
dan83590's Avatar
dan83590
Scooby Regular
 
Joined: Aug 2006
Posts: 3,214
Likes: 0
Default

Nice one..
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
s_tubb23
General Technical
4
Oct 14, 2015 07:58 PM
ALi-B
Other Marques
18
Sep 28, 2015 08:29 PM
alex_00s
Drivetrain
2
Sep 26, 2015 06:07 PM
Mister:E
Subaru Parts
2
Sep 24, 2015 01:37 PM
JohnSmith
Security
7
Sep 19, 2015 07:55 PM




All times are GMT +1. The time now is 06:19 AM.