momo wheel fitting to 97 facelift uk turbo
#1
momo wheel fitting to 97 facelift uk turbo
Is there a way of fitting a non airbag momo boss and wheel to replace the standard wheel on the facelifted 97model?
I took mine off today to be confronted with the fitting behind the wheel with the long piece of tape wrapped around it . The splines fit ,but the afore mentioned fitting gets in the way .I'm not worried about the airbag light at all but obviously need the horn to work . Any ideas anyone ??
I took mine off today to be confronted with the fitting behind the wheel with the long piece of tape wrapped around it . The splines fit ,but the afore mentioned fitting gets in the way .I'm not worried about the airbag light at all but obviously need the horn to work . Any ideas anyone ??
#2
Former Sponsor
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
I think you are taking about the ring that transfers the wiring to the air bag and horn?
It has a plug in the top of it with the airbag wires coming out of it etc?
other than the horn you won't need it.. although I believe it does cancel the indictors also when the wheel straightens..
You need to sort something else for the horn wiring.
Simon
It has a plug in the top of it with the airbag wires coming out of it etc?
other than the horn you won't need it.. although I believe it does cancel the indictors also when the wheel straightens..
You need to sort something else for the horn wiring.
Simon
#4
Ive done it, fitted a momo race used a legacy (non airbag) boss & horn adaptor (the new plastic ring to replace the airbag type one, take the plug and a length of wire from the loom of the donor legacy too)
from wat i remember there are a couple of wires to solder between the two but all will become clear when you see a legacy as the wires are the same colour.
from wat i remember there are a couple of wires to solder between the two but all will become clear when you see a legacy as the wires are the same colour.
#5
Thanks very much.
Not trying to be fussy though, but is there a way of modifying the airbag ring -such as opening up the plastic fitting that sticks out of it with the airbag and horn wiring inside -and then isolating just the horn wires and removing all the ones to the airbag .I reckon this might allow the momo boss to sit on top with 2 holes drilled in it for the locating prongs .
Not trying to be fussy though, but is there a way of modifying the airbag ring -such as opening up the plastic fitting that sticks out of it with the airbag and horn wiring inside -and then isolating just the horn wires and removing all the ones to the airbag .I reckon this might allow the momo boss to sit on top with 2 holes drilled in it for the locating prongs .
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
blockhead
Subaru Parts
19
07 November 2015 11:50 PM