Anybody removed the fog light surrounds on a blobeye WRX.
Whats the best way to get them off, I notice some small cut outs I assume you use a screwdriver in these areas to release clips?
thanks

 

Large screwdriver wrapped with some gaffer tape. Prise the inner edge (side with slot) out and they then pivot a little to the outer edge (where there's a large leg/clip). Wiggle a bit and they should come out easily.

To refit, locate large peg/clip on outer edge, realign and when almost home a sharp thump on the inner edge with the side of the fist should locate it fully..

 

Thanks very much, I thought that must be the way but thought I would check first appreciate the help