Hi guys

I have an EJ20 (no other markings) NA motor. It's meant to be a 97/98.
The bore size is approx 91mm dia (old gasket bore 93mm ish) and stroke of 75mm ish, therefore around 1996cc, so deffo a 2 litre.

It's SOHC, manual adjust tappets, open deck, 211 tooth belt. The engine was bought from a reputable Subaru breakers but they neglected to give me a chassis number so I don't know if it's UK, Europe or JDM spec.

Right, down to my problem. A head gasket went and I'd ordered gaskets (photos below). They don't match what was on mine and foul the head drillings etc.

Here's my head:


Here's a shot of my old and new gaskets:


Can anyone please advise me where I can get a gasket to match & part number please?
This is doing my crunch, the only ones I can find from Cometic etc have the two angled holes at the top and bottom of the bores - not the 3 holes

Any help is much appreciated