Hi all,

I have a problem with my clutch pedal. The issue is that it's only effective in the last 10% of the pedal travel and the pedal stays near the floor. You can yank up the pedal and then it gets better for 5-10 uses, but then we are back to the floor.

I have tried to change the fluid, i.e. not air in the system. Does this sound like a defect master og slave cylinder?

Thanks in advance

 

did you bleed the cylinder off the car? If so, sounds like one of them is bypassing, more likely to be the master cylinder than the slave cylinder

 

Yes I am sure that all air is out of the system.

I'll try APi for a master cylinder.

Thanks

 

just a thought, is the clutch return spring fitted?, and was just saying aboyut the slave cyl as, as you know, the bleed nipple is at the lowest point...good design mr subaru :