P1 IN STI3
11 April 2007, 05:07 PM
Scooby Regular
Thread Starter
Join Date: Aug 2004
Location: East Sussex
Posts: 319
Likes: 0
Received 0 Likes
on
0 Posts
P1 IN STI3
Can i put a P1 engine in my sti3 if i use the p1 engine loom and ecu or is it more complicated?
11 April 2007, 05:17 PM
Former Sponsor
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Quote:
Originally Posted by
CRAIG R
Can i put a P1 engine in my sti3 if i use the p1 engine loom and ecu or is it more complicated?
if you use ecu, loom, maf etc etc then yes but are your heads scrap?
less hassle to get short engine?
Simon
11 April 2007, 05:31 PM
Scooby Regular
Thread Starter
Join Date: Aug 2004
Location: East Sussex
Posts: 319
Likes: 0
Received 0 Likes
on
0 Posts
My heads are not sti3 Simon as they are hydraulic.
Thanks for the info though
11 April 2007, 09:01 PM
Former Sponsor
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
annoying when someone has swapped out the sti3 heads
assuming they are phase 1.5 heads then the cams should be reasonable on your heads.
Simon
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Welloilbeefhooked
General Technical
0
11 September 2015 06:49 PM
mega_stream
ScoobyNet General
23
29 October 2002 04:15 PM
Darren king
ScoobyNet General
6
26 July 2002 12:55 PM
P1 IN STI3
11 April 2007, 09:01 PM
