I need to read an ABS fault code off my MY99 UK Turbo.

I've read the workshop manual and it says this can be done without the select monitor by grounding a terminal on the diagnostic connector.

Now this all seems fairly simple but i can find the dam connector. Theres a picture of it dangling from under the drivers side dash near the footwell to the right of where the ECU diagnostic plugs are but i've put my head under and can see a thing.

I'm just wondering if its taped up somewhere out of sight?


Do any of you guys know where it is?

Craig

 

has your car got a obd2 connector fitted on drivers side? i think they started fitting them in 1999.if so all the diagnostics is done through that i think
what you are looking for is a 16 pin plug that has slightly angled sides to it

HTH

 

Yes i do have the OBDII connector thats what you need the select monitor for. I'm looking to do it without the select monitor using the diagnostic connector as the workshop manual suggests.

Craig

 

On my facelift Classic they are fairly close to the ABS ECU, possibly taped to the loom as a dealer wouldn't use them. 2 longish pins and a small plug with 2 holes in it I think.