Apexi cel knock sensor
26 January 2007, 02:28 PM
#1
Scooby Newbie
Thread Starter
Join Date: Jul 2006
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
Apexi cel knock sensor
Hi All
Help please.
My check engine light is not illuminating. How do I alter the sensitivity, so the cel flashes when I encounter detination?
Cheers
Bob
Help please.
My check engine light is not illuminating. How do I alter the sensitivity, so the cel flashes when I encounter detination?
Cheers
Bob
26 January 2007, 03:13 PM
#2
Scooby Regular
Join Date: Jul 2000
Location: Lancashire
Posts: 2,209
Likes: 0
Received 0 Likes
on
0 Posts
What Knock Count are you seeing on the commander?
Are you sure the Knock CEL function is switched on?
You can't change the sensitivity in the commander only switch the function on and off, to change the level at which the CEL light is activated for Knock, IDC or MAF voltage you need the PC interface.
Andrew...
Are you sure the Knock CEL function is switched on?
You can't change the sensitivity in the commander only switch the function on and off, to change the level at which the CEL light is activated for Knock, IDC or MAF voltage you need the PC interface.
Andrew...
26 January 2007, 08:34 PM
#3
Scooby Regular
As above. There's a function in the 'etc' menu on your Commander which turns knock warning on and off. THe actual level of knock warning is set when mapping.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM