500ft/lb engine build advice
#1
Scooby Regular
Thread Starter
Join Date: May 2006
Location: Under the bonnet...still!
Posts: 592
Likes: 0
Received 0 Likes
on
0 Posts
500ft/lb engine build advice
Just some advice into what parts I would need to build a US STI engine to cope with hopfully 500/500 (realistically 450/450).
I have externals which should support this figure so just need to know engine internal parts that I will need please?
Heres what I know I'll need:
Pistons, rods, bolts, bearings, head studs, gaskets.
Cheers
Chris.
I have externals which should support this figure so just need to know engine internal parts that I will need please?
Heres what I know I'll need:
Pistons, rods, bolts, bearings, head studs, gaskets.
Cheers
Chris.
#3
Former Sponsor
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
Just some advice into what parts I would need to build a US STI engine to cope with hopfully 500/500 (realistically 450/450).
I have externals which should support this figure so just need to know engine internal parts that I will need please?
Heres what I know I'll need:
Pistons, rods, bolts, bearings, head studs, gaskets.
Cheers
Chris.
I have externals which should support this figure so just need to know engine internal parts that I will need please?
Heres what I know I'll need:
Pistons, rods, bolts, bearings, head studs, gaskets.
Cheers
Chris.
Simon
#4
Scooby Regular
Thread Starter
Join Date: May 2006
Location: Under the bonnet...still!
Posts: 592
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the replys, Ive had an offer of a pre buit short block @ a pretty good price so might go down that route & just sell my current engine on.
Thread
Thread Starter
Forum
Replies
Last Post
Sub-Subaru
General Technical
1
28 September 2015 12:47 PM
MightyArsenal
Wheels, Tyres & Brakes
6
25 September 2015 08:31 PM