Will this exhaust off a 2001 car fit my terzo 3?
#1
Will this exhaust off a 2001 car fit my terzo 3?
Will a blitz exhaust off a 2001 car (newage) fit on my terzo3? Am i right in thinking if its a 2.5 inch system the center and back box will bolt straight on?
+is there just one of the 3 hangers that wont fit? These are the pics of the system
http://i142.photobucket.com/albums/r...az/6e2d_12.jpg
http://i142.photobucket.com/albums/r...daz/75b0_0.jpg
+is there just one of the 3 hangers that wont fit? These are the pics of the system
http://i142.photobucket.com/albums/r...az/6e2d_12.jpg
http://i142.photobucket.com/albums/r...daz/75b0_0.jpg
Last edited by donny_daz; 01 January 2007 at 05:32 PM.
#3
Scooby Regular
Am in a similar dilemna
Bought a newage nur spec r for my ltd edition classic wagon, was 'told' it'd fit. Found the following;
1) The two rear hanger brackets on back box fit, third one will not, will require chopping and re-welding.
2) Newage downpipe is 4-5 inches longer so mid section from newage nur spec r is this much shorter.....
Will pay local power flow dealer a visit to see if they can chop and extend the mid section. Problem is local powerflow guy is a real tw@t from previous experience, may have to bite the bullet tho'......
BTW- Nur Spec R is 3 inch system but drops down to 2.5 near downpipe flange. Have a 3 inch downpipe so will remove the step down and extend & mod as necessary to bolt on the 3 inch DP.
Bought a newage nur spec r for my ltd edition classic wagon, was 'told' it'd fit. Found the following;
1) The two rear hanger brackets on back box fit, third one will not, will require chopping and re-welding.
2) Newage downpipe is 4-5 inches longer so mid section from newage nur spec r is this much shorter.....
Will pay local power flow dealer a visit to see if they can chop and extend the mid section. Problem is local powerflow guy is a real tw@t from previous experience, may have to bite the bullet tho'......
BTW- Nur Spec R is 3 inch system but drops down to 2.5 near downpipe flange. Have a 3 inch downpipe so will remove the step down and extend & mod as necessary to bolt on the 3 inch DP.
Last edited by AFRIKANZ; 01 January 2007 at 07:53 PM.
Thread
Thread Starter
Forum
Replies
Last Post
ossett2k2
Engine Management and ECU Remapping
15
23 September 2015 09:11 AM