legacy and sti engines
#1
Scooby Newbie
Thread Starter
Join Date: Mar 2006
Location: feltham
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
legacy and sti engines
a little help and advice needed my friends got a beelte and wants to put a subaru turbo lump in ive herd the sti block is stregnthend over the wrx and has forged pistons too apart from that is there other differences like the crank stronger ect also the legacy turbo engine is this any good as there 2.5s are these as strong as ive seen 2.5s in some older scoobys are these engines from this, im basically looking for a good strong engine which wont cost too much and will be reliable i apreciate any help thanks
#2
Scooby Regular
iTrader: (1)
Join Date: Aug 2005
Location: Manchester ish
Posts: 18,547
Likes: 0
Received 0 Likes
on
0 Posts
depends on your goals with regards to power output. The wrx and sti bottom ends are the same apart from the rods and pistons. The crank is the same (based on a same year comparison). If you friend is looking for 300bhp then a standard wrx bottom end is upto the job
Thread
Thread Starter
Forum
Replies
Last Post
Bazil_SW
Engine Management and ECU Remapping
24
21 September 2015 11:55 PM