Knocklink fitting help
#1
Scooby Regular
Thread Starter
Knocklink fitting help
I have my knocklink wired up, and have tested it and its working fine.
Now I'm trying to mount the bosch sensor on the block. I have been told that a 30mm M8 nut will fit in a threaded hole on the passenger side under the intercooler. I can't find this hole. Heres a picture of my block under the passenger side intercooler along with all the holes I can locate in it. I have tried an M8 bolt in the hole with an arrow on but it won't thread at all. Is this the right place?
Now I'm trying to mount the bosch sensor on the block. I have been told that a 30mm M8 nut will fit in a threaded hole on the passenger side under the intercooler. I can't find this hole. Heres a picture of my block under the passenger side intercooler along with all the holes I can locate in it. I have tried an M8 bolt in the hole with an arrow on but it won't thread at all. Is this the right place?
#4
Scooby Regular
Thread Starter
I have now put the sensor on the car, and its picking up a spanner tapping the metal next to it. However Isn't this the gearbox and not the block?
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
JonMc
Subaru Parts
22
06 February 2016 09:50 PM
blockhead
Subaru Parts
19
07 November 2015 11:50 PM
matt12
Engine Management and ECU Remapping
4
14 September 2015 09:36 AM