i'm thinking of installing a sparco steering wheel in my 2002 bugeye does anyone know what i will need to install it other than the wheel i'd like to remove it so i think i will need a snap off boss. But will i need anything else?

 

You'll need a Resistor to fool the airbag into thinking its there too, or go round with the airbag warning light on.

 

thanks do u know what value it is? also does anyone know if i need and installation boss and the snap off boss or will the snap off boss do both jobs?

 

Resistors should only a few quid... not sure what one you'd need though!
Normally the snap off kits are separate to the Boss Kits, someone at Demon Tweeks will know though, they're pretty helpful. Make sure you tell the insurance company if you remove an airbag, they may refuse to pay out personal injury claims if you don't!

 

thanks do u know how how many ohms the reistor needs to be?

 

sorted it 3.3 ohm 14p from Maplin

 

Where did you put this resistor?

 

Yes, any pics of the install?