MY99 ae802 ECU and remap.
#1
MY99 ae802 ECU and remap.
can anyone tell me if the ae802 ECU in a MY99 u.k is restricting when getting it tek3 remapped? or can it be mapped just the same as the ae800 or 801? was gutted to find the 802 a while back in my car, are there actually any advantages to having this version? (apart from pleasing the green party).
car to be mapped has certain engine mods...
full decat system with 3" down pipe
harvey smith headers
harvey smith slip jointed up pipe
forge vta
green panel filter
walbro 255 fuel pump
original TD04 turbo (alas )
car to be mapped has certain engine mods...
full decat system with 3" down pipe
harvey smith headers
harvey smith slip jointed up pipe
forge vta
green panel filter
walbro 255 fuel pump
original TD04 turbo (alas )
#2
Ecu Specialist
Any of the ecu's mentioned can be remapped and there would be no difference, the hardware is the same for each only the software (rom) changed
best regards
bob
best regards
bob
#3
just to say thanks bob. straight from the horses mouth as it were.
regarding the mods mentioned, what are the likely power figures. are the harvey smith headers and up-pipe likely to make much difference to the mapping?
regarding the mods mentioned, what are the likely power figures. are the harvey smith headers and up-pipe likely to make much difference to the mapping?
Last edited by apac; 12 October 2006 at 04:58 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM