wire into car
30 September 2006, 12:28 PM
#1
Scooby Regular
Thread Starter
Join Date: Jun 2006
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
wire into car
need some advice, ive put a new head unit in me scoob now i am wanting to up grade the speakers and add an amp to it. where is the best place to run a power wire to the back as their dosnt seam to be any obvious gromit that i can remove, or does it invole drilling a hole in the bulk head??? and advice would be appreciated muchly!!!
30 September 2006, 01:24 PM
#2
Scooby Regular
Join Date: Feb 2005
Location: Brighton no more
Posts: 2,170
Likes: 0
Received 0 Likes
on
0 Posts
I'd guess it may depend on what car you have 
, but have you checked the ICE section - the FAQ sticky has a bit about fitting a new HU (and iPod adaptor) in an 05 WRX which needed a power feed wiring in. No bulkhead drilling required...
, but have you checked the ICE section - the FAQ sticky has a bit about fitting a new HU (and iPod adaptor) in an 05 WRX which needed a power feed wiring in. No bulkhead drilling required...
30 September 2006, 07:59 PM
#4
Scooby Regular
Join Date: Mar 2003
Posts: 231
Likes: 0
Received 0 Likes
on
0 Posts
Yeah mate i suppose it would depend on what car you have. On my1995 wrx there is the grommit on the passenger side behind the dash which makes it nice and easy to run a wire or two through.
Goodluck mate.
Goodluck mate.
Thread
Thread Starter
Forum
Replies
Last Post
ossett2k2
Engine Management and ECU Remapping
15
23 September 2015 09:11 AM