Boost solenoid fitting.
#1
Scooby Regular
Thread Starter
Join Date: Dec 2002
Location: SMACS
Posts: 876
Likes: 0
Received 0 Likes
on
0 Posts
Boost solenoid fitting.
Will need to fit a 3 port boost solenoid to my sti8 on the day of remap.
Anyone got any instuctions how to fit, as it has a different electircal connection. Also the old one only has 2 pipes going to it.
Anyone got any instuctions how to fit, as it has a different electircal connection. Also the old one only has 2 pipes going to it.
#2
Former Sponsor
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
remove current pipe work from actuator, compressor cover and air intake along with the T piece.
3port connects - top connection to compressor cover, middle connection to actuator, and bottom to the air intake..
Electrical connection is like for like on the wires.. cannot remember the colours but if red strip then it goes to the red etc..
Simon
3port connects - top connection to compressor cover, middle connection to actuator, and bottom to the air intake..
Electrical connection is like for like on the wires.. cannot remember the colours but if red strip then it goes to the red etc..
Simon
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM