(1996 wrx saloon) hi my gear box has been swapped at some point from an auto to a manual , the gear box has a neutral switch on but its not connected, just the wirs for the reverse lights, can some one please tell me what wires fronm the auto loom need to be connected to this manual neutral switch? or if not the precise pin /s on the ecu which have to be connect to the neutral switch?, (and neutral switch pin outs?)

im not getting any rev dropping or stalling as which is normally noted , but scooby clinic advise i sort this so any help would be great, thanks rob

 

any techies out there upto the challenge? cheers rob

 

it is connector B95 pin 10

whcih is the connector with the least number of wires on the ecu, which is under the kick plate in the passenger footwell.

Simon

 

Just something to note - my Power FC was mapped when my neutral switch was on the blink. Replaced it but it makes no difference to running whatsoever.

 

thanks for info, on the neutral switch plug theres is 4 pins , does any one know what each of these are? ie what to connect them to? feeds etc?

cheers rob

 

any one know which wires need to be connected to the neutral switch ie all ecu ones? as the theres a plug on top of my box that has about four/five connectors in it, two of these are for the reverse lights which are connected but does any one know what the others need to be connected too ecu wise? and there associated colours from the neutral switch to indicate which wire is which. alot to ask but if you do ill send you a fiver via paypal for your trouble. cheers rob