Head Extraction
#1
Head Extraction
Any one got any clues as to the beast way of getting the heads of an impreza engine turbo 2000 once engine is out need to take main cover off but cant find a way of loosning the bolt on the tensioner without turning the engine over as i have no gearbox connected
Help!!!!
Help!!!!
#2
Scooby Senior
Join Date: Feb 2003
Location: West Midlands
Posts: 1,903
Likes: 0
Received 0 Likes
on
0 Posts
There should be a hole on the side of the block so you can use a bolt/flat head screw driver to lock the flywheel.
If your talking about the cam wheel then air tool usually works, otherwise you will need a tool to lock & hold each cam wheel whilst the main bolts are undone.
If your talking about the cam wheel then air tool usually works, otherwise you will need a tool to lock & hold each cam wheel whilst the main bolts are undone.
#4
Scooby Senior
Join Date: Feb 2003
Location: West Midlands
Posts: 1,903
Likes: 0
Received 0 Likes
on
0 Posts
It would be easier to look at the flywheel & then look around the left hand side of the block casing, the hole should line up with the cog/teeth of the flywheel.
Thread
Thread Starter
Forum
Replies
Last Post
bluebullet29
General Technical
9
05 October 2015 02:17 PM